Physics 9702/33 February/March 2020: question paper and mark scheme
Cambridge AS & A Level Physics (9702), Paper 3 Advanced Practical Skills 1, February/March 2020. Read both free below, or download them. Done the paper? Get it marked by AI against this mark scheme.
In this experiment you will investigate the oscillations of a rod.
(a) • Assemble the apparatus as shown in Fig. 1.1.
• Adjust the apparatus until the two springs are approximately 15 cm apart. Each spring should be vertical and the same distance from the middle of the rod. The rod should be parallel to the bench.
clamp boss
spring rod
x
stand
bench
Fig. 1.1
• The distance between the two springs where they support the rod is x, as shown in
Fig. 1.1. Measure and record x.
x = …… cm [1]
(b) • Lift one end of the rod a short distance and push the other end of the rod down a short distance. Release the rod so that it oscillates with a rocking motion, as shown in Fig. 1.2.
FRONT VIEW
Fig. 1.2
• Take measurements to determine the period T of the oscillation.
T = …… s [2]
(c) • Change x by moving the stands. Adjust the apparatus until the springs are vertical and the rod is parallel to the bench. Measure x and T.
• Repeat until you have six sets of values of x and T.
1
• Record your results in a table. Include values of x in your table.
[9]
1
(d) (i) Plot a graph of T on the y-axis against x on the x-axis. [3]
(ii) Draw the straight line of best fit. [1]
(iii) Determine the gradient and y-intercept of this line.
gradient = ……
y-intercept = ……
[2]
(e) It is suggested that the quantities T and x are related by the equation a
T=x+b
where a and b are constants.
Use your answers in (d)(iii) to determine the values of a and b.
Give appropriate units.
a = ……
b = ……
[2]
[Total: 20]
You may not need to use all of the materials provided.
Mark scheme
1(a) Value of x in range 10.0 to 20.0 cm 1
1(b) Value of T in range 0.50 to 1.50 s 1
Evidence of repeat readings: at least two values of at least 5T 1
1(c) Six sets of readings of x and T with correct trend and without help scores 4 marks, five sets scores 3 marks etc. 4
Range: 1
xmin ⩽ 12.0 cm and xmax ⩾ 25.0 cm
Column headings: 1
Each column heading must contain a quantity and a unit where appropriate
The presentation of quantity and unit must conform to accepted scientific convention e.g. 1 / x (cm–1)
Consistency: 1
All values of raw x must be given to the nearest mm
Significant figures: 1
All values of 1 / x should be to the same s.f. as (or one more than) the s.f. in the corresponding x value
Calculation: 1
Values of 1 / x calculated correctly
1(d)(i) Axes: 1
Sensible scales must be used, no awkward scales (e.g. 3:10)
Scales must be chosen so that the plotted points occupy at least half the graph grid in both x and y directions
Scales must be labelled with the quantity which is being plotted.
Scale markings should be no more than 3 large squares apart.
Plotting of points: 1
All observations must be plotted on the grid.
Diameter of plotted points must be ⩽ half a small square (no blobs).
Plots must be accurate to within half a small square in both x and y directions.
Quality: 1
All points in the table must be plotted (at least 5) for this mark to be awarded. Scatter of plots must be no more than ± 0.5 m–1
(± 0.005 cm–1) from a straight line in the x-direction.
1(d)(ii) Line of best fit: 1
Judged by balance of all points on the grid (at least 5) about the candidate’s line. There must be an even distribution of points
either side of the line along the full length
One anomalous point is allowed only if clearly indicated (i.e. circled or labelled) by the candidate.
Lines must not be kinked or thicker than half a square.
1(d)(iii) Gradient: 1
The hypotenuse of the triangle used must be greater than half the length of the drawn line.
Method of calculation must be correct.
Both read-offs must be accurate to half a small square in both the x and y directions.
y-intercept: 1
Either
Correct read-off from a point on the line substituted into y = mx + c or an equivalent expression, with read-off accurate to half a
small square in both x and y directions.
Or
Intercept read directly from the graph, with read-off at x = zero accurate to half a small square in y direction.
1(e) a equal to candidate’s gradient, and b equal to candidate’s intercept. 1
a and b are not fractions.
a has two or more significant figures.
1(e) Units for a and b correct (e.g. s cm or s m for a, and s for b). 1
In this experiment you will investigate the magnetic field produced by an electrical current.
(a) You are provided with a length of wire wrapped around a plastic channel to form a coil, as shown in Fig. 2.1.
grooves
plastic channel
tape
wire (wrapped through every other groove)
Fig. 2.1
Count and record the number N of turns of wire in the coil.
N = …… [1]
(b) • Slide the compass into the plastic channel so that it is in the middle of the coil.
• Connect the circuit as shown in Fig. 2.2.
• Rotate the channel on the bench until the arrow of the compass is perpendicular to the channel, as shown.
L
compass inside crocodile plastic channel crocodile clip clip
A
Fig. 2.2
• The distance between the first and last turns of wire is L, as shown in Fig. 2.2. Measure and record L.
L = …… [1]
(c) • Close the switch. The compass arrow will rotate through an angle θ.
• Measure and record θ.
θ = …… °
• Record the ammeter reading I.
I = ……
• Open the switch.
[2]
(d) Estimate the percentage uncertainty in your value of θ.
percentage uncertainty = …… [1]
(e) Calculate the value of B using μ0(N−1) I
B= L where μ0 = 1.26 × 10–6 N A–2.
B = …… N A–1 m–1 [1]
(f) • Disconnect the crocodile clips and remove the compass.
• Remove the tape and the wire. Re-wind the wire in adjacent grooves (instead of every other groove), as shown in Fig. 2.3.
• Re-fix the tape.
Fig. 2.3
• Repeat (a), (b), (c) and (e).
N = ……
L = ……
θ = …… °
I = ……
B = …… N A–1 m–1
[3]
(g) It is suggested that the relationship between θ and B is
B tan θ = k
where k is a constant.
(i) Using your data, calculate two values of k.
first value of k = ……
second value of k = ……
[1]
(ii) Justify the number of significant figures you have given for your values of k.
…… [1]
(iii) Explain whether your results in (g)(i) support the suggested relationship.
…… [1]
(h) (i) Describe four sources of uncertainty or limitations of the procedure for this experiment.
1 ……
2 ……
3 ……
4 ……
[4]
(ii) Describe four improvements that could be made to this experiment. You may suggest the use of other apparatus or different procedures.
1 ……
2 ……
3 ……
4 ……
[4]
[Total: 20]
Mark scheme
2(a) Value of N, with no unit, in range 10 to 14. 1
2(b) Value of L to nearest mm, with unit, in range 5.0 to 15.0 cm. 1
2(c) Value(s) of raw θ to nearest degree and < 90°. 1
Value of I to nearest mA or nearest 0.1 mA, with unit 1
2(d) Absolute uncertainty in θ value of 2 to 5° and correct method of calculation to obtain percentage uncertainty. 1
If several readings have been taken, then the absolute uncertainty can be half the range (but not zero if values are equal) if
the working is clearly shown.
2(e) Correct calculation of B 1
2(f) Second values of N and L 1
Second values of θ and I 1
Quality: second θ > first θ 1
2(g)(i) Two values of k calculated correctly. 1
2(g)(ii) Justification based on s.f. in θ, I and L. 1
2(g)(iii) Sensible comment relating to the calculated values of k, testing against a criterion specified by the candidate. 1
2(h)(i) Two readings are not enough to draw a valid conclusion 4 max 4
Difficult to determine I as reading not steady
Parallax error when measuring θ
Large % uncertainty in θ
Difficult to re-wind and fix the wire / wires may touch / wire is kinked
Channel moves on bench
2(h)(ii) Take more readings and plot a graph / calculate more k values and compare 4 max 4
Method of cleaning crocodile clips / contacts
Method of overcoming parallax error,
e.g. measure change of angle by turning channel on bench / measure θ on a photo / angle markings on compass / mark
‘before’ and ‘after’ positions on compass
Use larger current / voltage
Use two ready-wound channels / use new wire
Method of fixing channel, e.g. tape channel to bench
Checked your answers against these? Let AI mark the whole paper, on your own working.
Examiners follow the generic marking principles at the front of the scheme, then each question's points: method (M), accuracy (A) and independent (B) marks, error carried forward where the scheme allows it, and positive marking, so you're credited for what you got right.
Check your answers against it
Done this paper? Upload your script and CIE Buddy's AI marker marks it question by question against this exact scheme, puts the ticks on your own working and says what each lost mark needed.
Where can I find the 9702/33 February/March 2020 mark scheme?+
On this page, free: the mark scheme for AS & A Level Physics 9702/33, February/March 2020 (9702_m20_ms_33), and the question paper (9702_m20_qp_33), to read or download, with each question's marking points written out underneath.
How many marks is 9702/33 out of?+
Physics 9702/33 for February/March 2020 is out of 40 marks, with 2 hours to answer it, across 2 questions.
Can I get my 9702/33 answers marked?+
Yes. Upload your answers to 9702/33/F/M/20 as a PDF or photos, and CIE Buddy marks every question against this paper's official mark scheme, using Cambridge's marking rules. You get your score, each lost mark explained on your own script, and the topics to revise. It's a guide, not an official Cambridge grade.